home
StrataCafe Forums
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 Older Forums
 Strata Enfold 3D CX
 Resolution dependent
 Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

Hopper2
Regularly Helpful

USA
727 Posts

Posted - 11/23/2009 :  11:39:03  Show Profile
This question is a duplicate on the Live 3D forum too!

I have created two 3D pdf's for two different (physical) size boxes. One box is physically larger than the other. When I get through the Live3D process the look of the larger box is much courser and appears to be of a lower resolution. The two UV maps seem to be held within a 1024 width. The larger is 1024x512 landscape the smaller boxes UV map is 1024x1024. The final question is does the Enfold have an outer limit to create UV maps of adequate resolution of large boxes, to then create a decent 3D resolution3D pdf?

Hope this makes sense!

Hopper

jpro
A Fountain of Information

USA
4991 Posts

Posted - 11/23/2009 :  12:38:24  Show Profile  Visit jpro's Homepage
yes, 1024 x 1024 is the current max res.

If you need higher, you need to recreate the maps as we have discussed here before.

Jean
Go to Top of Page

Hopper2
Regularly Helpful

USA
727 Posts

Posted - 11/23/2009 :  15:19:31  Show Profile
I know about swopping up to a higher res. My question was, inherently would a larger box in essences create an apparent lower resolution image because you are starting from that larger size. I think it would. This is a relative size question. Hope this makes sense!

Hopper
Go to Top of Page

jpro
A Fountain of Information

USA
4991 Posts

Posted - 11/23/2009 :  15:25:19  Show Profile  Visit jpro's Homepage
well, yes, of course it would. You are using the same number of pixels in a much larger area.

Jean
Go to Top of Page

Hopper2
Regularly Helpful

USA
727 Posts

Posted - 11/23/2009 :  16:14:05  Show Profile
That's what I thought and thanks Jean!!

Hopper
Go to Top of Page

jpro
A Fountain of Information

USA
4991 Posts

Posted - 11/23/2009 :  16:47:22  Show Profile  Visit jpro's Homepage
and of course, that is assuming that all that I am assuming about an unseen project is correct....

Jean
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
StrataCafe Forums © 2009 StrataCafe Go To Top Of Page
Snitz Forums 2000