StrataCafe Forums
Save Password
Forgot your Password?

 All Forums
 Strata Design 3D CX
 Extrude/Bevel imported text
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

A Regular

405 Posts

Posted - 02/22/2018 :  13:27:44  Show Profile  Reply with Quote
I am using a non truetype font which was imported from Illustrator as a text string (a headline). I have extruded the text, but since the characters are imported as a group, I don't have access to the bevel characteristics as grouped text.
Double clicking the grouped text invokes a window where the individual letters can be altered with the bevel controls. But I have to manually set each letter to match. Very time consuming in a text string. Can individual letter bevel settings be saved or copied then applied to the additional characters (without manually setting all characteristics)?

In some cases, I know I could create one letter with desired bevel, drag copy the letter, then change the character (while maintaining the bevel settings) But in this case, the letters were imported on an arc, so I would need to reposition, and rotate each letter. not a time saver.


Edited by - Stratagizer on 02/22/2018 13:31:03

A Regular

433 Posts

Posted - 02/23/2018 :  04:51:12  Show Profile  Reply with Quote
Isn't it possible to flatten the whole group of letters into the same mesh by selecting the group and converting it to a mesh?
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
StrataCafe Forums © 2009 StrataCafe Go To Top Of Page
Snitz Forums 2000